Inlet
Outlet
Priming Port
RESET
RESET
TEST
TEST
On/O
Switch
Water Source
Maximum
20 Ft.
Vertical
Distance
Foot Valve
2. Connect garden hose or 1-in pipe to pump inlet
and outlet.
3. Remove priming nut on pump and ll cavity
with water. Reinstall priming nut.
4. Turn the switch to the ‘off’ position and plug
power into GFCI outlet. Turn the switch to the
‘on’ position to begin pumping.
SW1117 B
QUICK START GUIDE.
SEE INSTRUCTION
MANUAL FOR
COMPLETE DETAILS.
ITEM #0955585
BOOSTER
UTILITY PUMP
MODEL #
148008
Printed in China
WARNING:
FOR YOUR PROTECTION, ALWAYS DISCONNECT
PUMP FROM POWER SOURCE BEFORE HANDLING.
1. Set pump as close as possible to the water
source, keeping the vertical distance from the
water to pump as short as possible and no more
than 20 ft.
A foot valve with strainer (not provided) should
be installed at the end of the suction hose or
pipe to maintain prime during operation.
To Next Page
Need help?
General
