• (1) Make sure your dive computer has enough battery capacity with at least 5 segments.
Note: In case your dive computer’s battery capacity is lower than 5 segments, have the battery replaced
as the software update will not load with insucient voltage.
• (2) Switch o any battery and screen saving modes on your mobile device, as it may interrupt the
Bluetooth communication.
• (3) Activate Bluetooth on the dive computer and on your mobile device.
• (4) Launch LogTRAK on your mobile device.
• (5) Establish connection between your dive computer and mobile device by pressing connect
SCUBAPRO.COM
ALADIN SERIES
FIRMWARE UPDATE PROCEDURE via ANDROID
ALADIN SPORT/ONE/HOSE MATRIX, ALADIN A1 & ALADIN A2
A new firmware is available for your ALADIN dive computer.
• (6) Once you connect and synchronize your dive computer within LogTRAK, a firmware update notification
will appear.
To Next Page
Need help?
General
