ENGLISH
24
IMPORTANT REMARKS
For any installation problems please contact
V2 ELETTRONICA TEL. (+39) 01 72 81 24 11
V2 ELETTRONICA has the right to modify the
product without previous notice; it also
declines any responsibility to damage or
injury to people or things caused by improper
use or wrong installation.
mPlease read this instruction manual very
carefully before installing and programming
your PD5 - PD7 control unit.
• This instruction manual is only for qualified
technicians, who specialize in installations and
automations.
• The contents of this instruction manual do not
concern the end user.
• Every programming and/or every maintenance
service should be done only by qualified
technicians.
The PD5 - PD7 control unit can drive one or more
electromechanical actuators for the automation of
swing doors and swing gates. Any other utilization
is not in specification.
AUTOMATION MUST BE IMPLEMENTED IN
COMPLIANCE WITH THE EUROPEAN
REGULATIONS IN FORCE:
EN 60204-1
(Machinery safety. electrical
equipment of machines, part 1:
general rules)
EN 12445 (Safe use of automated locking
devices, test methods)
EN 12453 (Safe use of automated locking
devices, requirements)
• The installer must provide for a device (es.
magnetotermical switch) ensuring the
omnipolar sectioning of the equipment from
the power supply. The standards require a
separation of the contacts of at least 3 mm in
each pole (EN 60335-1).
• After making connections on the terminal
board, use one hose clamp to fix dangerous
voltage wires near the terminal board and
another hose clamp to fix safety low voltage
wires used f
or accessor
ies connection;
this
way, in case of accidental detachment of a
conducting wire, dangerous voltage parts will
not come into contact with saf
ety lo
w v
oltage
ones.
• The plastic case has an IP55 insulation; to
connect flexible or rigid pipes, use pipefittings
having the same insulation level.
• Installation requires mechanical and electrical
skills, therefore it shall be carried out by
qualified personnel only, who can issue the
Compliance Certificate concerning the
whole installation (EEC Machine Directive
89/392, Annex IIA).
• The automated vehicular gates shall comply
with the following rules: EN 12453, EN 12445,
EN 12978 as well as any local rule in force.
• Also the automation upstream electric system
shall comply with the laws and rules in force
and be carried out workmanlike.
• The door thrust force adjustment shall be
measured by means of a proper tool and
adjusted according to the max. limits, which
EN 12453 allows.
• We recommend to make use of an emergency
button, to be installed by the automation
(connected to the control unit STOP input) so
that the gate may be immediately stopped in
case of danger.
• Always remember to connect the earth
according to current standards (EN 60335-1,
EN 60204-1).
CONFORMITY TO REGULATIONS
V2 ELETTRONICA SPA declares that PD5 - PD7
is in conformity with the provisions of the
followings 93/68/EEC, 73/23/EEC, and with the
standards referenced here below:
EN 60335-1: Electrical safety
EN 50081-1, EN 50081-2: Electromagnetic
compatibility
Racconigi, 15 / 10 / 01
V2 ELETTRONICA SPA legal representative.
A.Livio Costamagna
To Next Page
Loading...
Need help?
General
