To Next Page

To Previous Page

ENGLISH

- 11 -

INSTALLING THE MOTOR REDUCER

1. Place the motor reducer gear unit inside the foundation box.

2. Fix the motor reducer in place inside the foundation box by

tightening the 4 nuts.

INSTALLATION OF THE STOP LIMIT SWITCHES

1. Place the gate in the maximum closed position, and then

attach the limit switch screw as shown in the ﬁgure.

2. Place the gate in the maximum open position, and then attach

the limit switch nut as shown in the ﬁgure, and tighten the

screw.

3. Mount the motor connecting rod on the motor drive shaft and

ﬁx the screw in place using the corresponding self-locking nut.

Connect the motor connecting rod to the control rod by means

of the elbow lever.

Connect the motor to the control unit, following the

instructions in the following paragraph.

Other manuals for V2 Vulcan

Questions and Answers:

Need help?

Do you have a question about the V2 Vulcan and is the answer not in the manual?

General