VSP-V-2000
Issue 6
1 947200
V-2000
INTEGRATED SINGLE ZONE PAGE CONTROL UNIT
INTRODUCTION
The V-2000 is an Integrated Single Zone Paging
Control Unit for use with any electronic key or
PABX. The control unit provides external power (12
Valcom power units) for powering Valcom One-Way
Amplified Speakers.
These instructions contain the specifications and
information necessary to install, operate, and maintain
the Integrated Single Zone Paging Control Unit.
"WARNING: To reduce the risk of fire or
electric shock, do not expose this appliance
to rain or moisture."
"WARNING: Shock Hazard - Do Not Open."
"AVIS: Risque de Choc Electrique ne pas
Ouvrir."
"PELIGRO: Corriente Elecrica - No Abra."
SPECIFICATIONS
Purpose
• Provides telephone system access to a single
zone of one-way paging.
Applications
• Electronic Key Systems
• PABXs
• 1A2 Key Systems (400 type line card required)
• Stand Alone Systems
Refer to Figure 1 for a block diagram of a typical
installation.
Features
• Electronic key system line key access
• PABX loop start trunk port access
• Page port access
• Switchable battery feed for loop start operation
• RJ11 for Tip and Ring connections
• Power on LED
• Drives up to 150 Valcom one-way amplified
speaker assemblies (audio)
• Background music input
• Voice operated switch to mute music during page
• Screw terminals provided for all connections
• UL Listed
• Supplies 12 Valcom power units for powering
Valcom one-way amplified speakers
• May be used with 25 or 70 volt amplifiers
• AC powered
• AC input fused at .5 amp
Capacity
• The V-2000 is a one zone single talkpath unit.
• Each V-2000 will drive up to 150 Valcom
One-Way amplified speaker assemblies (audio)
and provides 12 Valcom power units for
powering the speaker amplifier assemblies. (The
V-2000 can also be used
to access 25 or 75 volt
conventional amplifiers)
To Next Page
Need help?
General
