V22 INTEGRA Reset - Window Only Reset - Electric & Solar
Note: If you have other products installed these will also move up and down (e.g. blinds)
Note: If there is more than one window, repeat the above steps for all windows.
Press the reset button on the window. This is located in one of two places dependant on the window
type, as below.
For sloping roof windows, push down
on the lever to the right of the T-Bar
and locate the reset button as shown:
For flat roof windows, remove the
cover cap on the window frame to
locate the reset button as shown:
Press and hold the reset button for at least 15 seconds (ensure you continue to hold the button
even when the chain moves)
The chain will move in and out several times.
Once the product stops moving, close the window ensuring the vent bar is fully closed. For electric
INTEGRA windows only, switch the power off to the window for at least 60 seconds.
Now, add the 'New' window to the wall switch or handset, as below.
To Next Page
Need help?
General
