EasyManuals Logo
Home>Vertiv>Switch>CYBEX SC 840D

Vertiv CYBEX SC 840D Quick Installation Guide

Vertiv CYBEX SC 840D
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
590-1485-501A
1
VERTIV™ CYBEX™ SC 840D/845D
AND 940D/945D KVM SWITCHES
Quick Installation Guide for 4-Port DisplayPort
The following instructions will help
you install your Vertiv™ Cybex SC
840D/940D/845D/945D switch.
WARNING: This product is equipped
with active intrusion protection. Tamper-
ing may permanently disable the switch
and void the warranty. If the enclosure
appears to have been tampered with or
if all the port LEDs ash continuously,
please contact Technical Support. This
product also has tamper evident seals.
Broken or removed seals will void the
warranty.
1. Connecting local peripherals
Turn o all computers you
plan to use with your SC
840D/940D/845D/945D switching
system. Plug the monitor cable
into the appropriate CONSOLE
port on the back of the switch.
Plug the USB or PS/2 keyboard
and mouse cables, speaker or
headset cable and Common
Access Card (CAC) device into the
appropriate ports.
2. Turning on your system
Turn the monitor on. Plug the
power supply cord into the switch.
Plug the other end of the power
supply cord into an AC wall outlet.
The display diagnostic LED should
be solid green a few seconds after
power is applied. This indicates the
display EDID information has been
captured and secured.
3. Connecting computers to the
switch
Make sure all computers are turned
o. Plug the monitor, speaker,
keyboard and mouse cables from
the corresponding computer into
one of the ports on the switch.
Repeat for all computers.
NOTE: The cables must be
connected directly to a free USB
port on your computer with no USB
hubs or other devices in between.
4. CAC device conguration
and operation (applies to SC
845D and SC 945D models
only)
Using a USB cable, connect one
end of the cable to the computer
that requires CAC, and the other
end to the CAC port on the
switch that corresponds to the
computer. Enable CAC for the
port connection by switching the
CAC switch to the right. Repeat
the previous steps for additional
computers that require CAC.
1
1
3
4
2
Vertiv™ Cybex™ SC 945D Switch Shown

Other manuals for Vertiv CYBEX SC 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vertiv CYBEX SC 840D and is the answer not in the manual?

Vertiv CYBEX SC 840D Specifications

General IconGeneral
BrandVertiv
ModelCYBEX SC 840D
CategorySwitch
LanguageEnglish

Related product manuals