November 5, 2015 1/10
Operating instructions for electronics
Initial startup (m, °C, 24h)
The functions of the Traveller can be
checked when the battery is inserted:
1. Segment check Do all segments
light up?
2. Beep tone Did you hear a
beep?
3. Background Is the light switched
lighting on briefly?
After this automatic function test, the present
altitude is first displayed briefly after which
the display changes over to the time mode.
The European system of units (height = m,
temperature = °C, time mode = 24h) is stand-
ard.
Initial startup (ft, °F, 12h)
To set the American system of units (height =
ft, temperature = °F, time mode = 12h). Insert
new battery, press the Victorinox emblem
while closing the battery compartment. The
function test then takes place as described
above.
C = continuous pressure
Menu choice
Press the Victorinox emblem briefly to select
the desired menu.
If the button is not pressed for more than 30
min in the "Altimeter", "Alarm" and "Tempera-
ture" menus, the display automatically reverts
to the time mode.
Background lighting
Press the Victorinox emblem for 1.5 seconds
to switch the background lighting on. The
light goes out again 3 seconds after the last
actuation. The background lighting is auto-
matically switched off on changeover to the
setting mode (except in the alarm function).
To Next Page
Need help?
General
