4. Editing the Effects.
The VT’s effects section may be edited. Use the Edit Knob (Edit 1); to dial in how much of the overall effect
is in the mix. Hold down the TAP button while turning the Edit Knob (Edit 2), to change a particular parameter
(depending on the effect selected). Hold down the Bypass button, while turning the Edit Knob (Edit 3), to change
another effect parameter. You can also tap the Tap, to a tempo, to set Delay Time and Modulation speed of
the effects. To hear the amp dry, you can simply press the Bypass button to bypass the effects. The glossy
POP on the top of the Amp tells you what parameters the edits are affecting. Notice that the VT series has an
independent Reverb circuit. The Reverb can be turned up and down by utilizing the Reverb Knob on top of the
amp’s face plate.
3. Using the Banks and Programs.
Press the User Programs button to access program mode. Use the Bank button to select either Green or Red. The
Green Bank has 4 programs, and the Red Bank has 4 separate programs, allowing the VT to save and change
up to 8 programs total. These 8 programs serve as an additional 8 presets. Remember; let the presets do the
work, as there are many styles and effects, already dialed in, among the presets.
To Next Page
Loading...
Need help?
General
