21
Appendix
I want to use my cordless headset with a different telephone base.
You need to deregister the headset from the current telephone base (page 5) and then
register it to the new telephone base.
Make sure the power cord is securely plugged into the telephone base. Use a working
electrical outlet not controlled by a wall switch.
Reset your telephone by unplugging the power adapter from the telephone base.
Other electronic products such as HAM radios and other DECT phones can cause interference
with your cordless phone. Try installing your phone as far away as possible from these types
of electronic devices.
Common cure for electronic equipment.
If the unit is not responding normally, put the cordless headset in its charger. If it does not
respond, try the following (in the order listed):
- Disconnect the power to the telephone base.
- Wait a few minutes before connecting power to the telephone base.
- Remove and place the cordless headset in its charger.
- Wait for the cordless headset to synchronize with the telephone base. Allow up to one
minute for this to take place.
•
•
•
•
•
Troubleshooting
To Next Page
Loading...
Need help?
General
