4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
bottom of the unit, use a screwdriver
to loosen the screw, and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 1 new AA (LR6/AM-3) battery
following the diagram inside the
battery box. (For best performance,
alkaline batteries or fully charged
Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
Note: If there is no response when the unit is switched on, please
install brand new batteries and try switching the unit on again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
To Next Page
Loading...
Need help?
General