81/269
• Maintenance of screws and bolts:
Check the screws of each part carefully before using the scooter.
The screws must not be loose or too damaged.
Note: Check that the scooter is functioning normally before each use. If
there is a problem, do not use it and contact the after-sales service to
have it repaired. Never modify the structure of the scooter. Any
modification may result in a risk of injury, and the manufacturer will not
be liable for any damage resulting from such modification.
Disc brake adjustment
The pads exert pressure on a disc attached to the wheel hub. The
intensity of the pressure is controlled by a brake lever, depending on
the force applied by the user. Do not operate the brake lever when the
wheel is detached from the frame or the fork.
To adjust the braking force slightly, turn the micro-adjustment screw.
To align the mechanical disc brake caliper, loosen the fixing screws of
the brake caliper support.
Brake with the corresponding brake lever (the brake caliper is positioned
correctly) and hold the brake lever in this position while re-tightening the
caliper bracket fixing screws.
To Next Page
Loading...
Need help?
General
