Standard Timer
Switching the
heater on
General
Switching the
heater off
Operation
Setting time/
day of the
week
Viewing
the time
Programming
heater starting
time
Recalling/
erasing preset
times
Programming
duration of
operating time
Setting the
remaining
operating time
Setting the
wakeup time
Recalling/
erasing the
wakeup time
Remote control
Manually: by pressing the button (continuous heating mode)
Automatically: by programming the heater starting time
The standard digital timer enables you to preset the start of the
heater operation up to 7 days in advance.
It is possible to program 3 different starting times, only one of which
can be activated.
The standard digital timer features a wakeup alarm function.
When the ignition switched on, the timer displays the current time
and the day of the week. When the heater is switched on, the display
and the buttons are illuminated.
After the power supply has been connected, all symbols on the
display will flash. The current time and weekday must be set.
The timer can be operated in that all flashing symbols can be
adjusted by means of the and buttons. If the buttons are not
pressed within 5 seconds, the time displayed will be stored. If the
and buttons are pressed for more than 2 seconds, the fast time-
setting mode is activated.
If the ignition is switched off while the heater is operating in the
continuous mode, the remaining operating time of 15 minutes is
displayed and the heater continues to operate for this period of time.
Manually: by pressing the button
Automatically: after the programmed operating time has elapsed
With the heater running: by programming the remaining operating time
Press the button for more than 2 seconds - time of the day is
flashing - and set the clock using the and buttons. Day of the
week is flashing - adjust the day of the week.
With the ignition switched off: press the button
Press the button - the memory location is flashing - using the
and buttons set start of the heater operating time. Day of the week
is flashing - set the day of the week. By repeatedly pressing the
button, memory locations 2 and 3 can be programmed or the time
display mode can be reached.
Repeatedly press the button until the desired memory location is
displayed. To erase the preset time, press the button several
times until the time of the day is displayed instead of the memory
The heater must be switched off. Press the button for 3 seconds -
operating time is flashing - and set the desired operating time (10 to
120 minutes) using the and buttons.
Set the desired remaining operating time (1 to 120 minutes) using the
and buttons. The remaining operating time refers to the time the
heater still continues to remain in operation. It can only be changed
while the heater is in operation and the ignition switched off.
A wakeup time can only be programmed on the standard digital timer.
The wakeup time is not bound to a specific day of the week.
Repeatedly press the button until the bell symbol appears on
the display. Set the desired wakeup time using the and
buttons.The alarm clock turns off after 5 minutes or when one of the
buttons is pressed.
Repeatedly press the button until the bell symbol appears on
the display - read off wakeup time. To erase the wakeup time: press
the button until the bell symbol is no longer visible on the
display.
Possible by means of an optional external "instant heating" button
day of the week heater "on" indicator
forward
Standard Timer
instant
heating
reverse
program
selection
time
alarm indicator
memory location
time display
2
MO
Vehicles
with ADR
equipment
On ADR vehicles it is not possible to program a preset starting time.
The remaining time is shown on the display while the heater is in
operation. The clock can be set. The alarm clock function can be
programmed on the standard digital timer.
To Next Page
Loading...
Need help?
General
