Light O
3. Plug power supply back into power strip.
4. Monitor the indicator lights on your booster. If, after 5 seconds of ‘power on’, a
solid or blinking red light appears, repeat steps 1 through 4. Increase the separa-
tion distance until the condition is corrected and/or desired coverage area is
achieved. Note: Parallel separation of the two antennas typically requires a shorter
separation distance than perpendicular separation. If possible, try placing the
antenna directly in front of the location of the booster. A combination of vertical
and horizontal separation distance also works to prevent oscillation.
5. If you are having any diculties while testing or installing your booster, contact
our weBoost Customer Support team for assistance (866.294.1660).
If the eqo Signal Booster’s light is o, verify your surge protected power
strip has power.
NOTE: The Signal Booster can be reset by disconnecting and reconnecting
the power supply.
NEED HELP?
866.294.1660support.weboost.com
(TROUBLESHOOTING cont.)
After troubleshooting you must initiate a new power cycle by disconnecting and
then reconnecting power to the Booster.
ALWAYS disconnect and reconnect power from the wall adapter, NEVER from the
Booster.
CELL PHONE SIGNAL BOOSTER
10
To Next Page
Loading...
Need help?
General
