上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
NcEditor V12 Laser Cutting CNC System User
Manual
Version: 2019.3 8th Version
Author: Document Department
Weihong Corporation, All Rights Reserved
1 Interface Overview ......................................................................................................................... 2
1.1 Toolbar ................................................................................................................................... 4
1.2 Drawing Window ............................................................................................................... 5
1.3 Running Information Bar ................................................................................................ 6
1.4 Window Display Buttons ................................................................................................ 7
1.5 Machine Control Area ....................................................................................................... 7
1.6 Status Bar ........................................................................................................................... 13
1.7 Drawing Toolbar ............................................................................................................. 14
1.8 3D View Area .................................................................................................................... 14
2 Quick Start (in Sheet Cutting Configuration) .................................................................... 16
2.1 Return to the Machine Origin ..................................................................................... 16
2.2 Load a Toolpath or Draw an Object ......................................................................... 18
2.3 Calibrate Capacitance .................................................................................................... 20
2.4 Set the Workpiece Origin ............................................................................................. 21
2.5 Find Edges .......................................................................................................................... 22
2.6 Simulate Machining ........................................................................................................ 26
2.7 Execute Machining .......................................................................................................... 27
3 Quick Start (in Tube Cutting Configuration) ..................................................................... 29
3.1 Set Type and Dimension of a Tube ........................................................................... 29
3.2 Level and Center a Tube ............................................................................................... 30
3.3 Load a Toolpath or Draw an Object ......................................................................... 31
To Next Page
Need help?
General
