Assemble the Stand Legs
1. Align the circular holes on bracket with the left and right stand legs.
2. Insert the 4X12 screws into the holes and fasten.
Assembly
Check the Package Contents
1 2
3
4
65 7 8 9 10 11
1. LEFT STAND LEG 1
2. RIGHT STAND LEG 1
3. CROSS BOARD 1
4. FOOT 2
5. BRACKET 4
6. CROSS BOARD BRACKET 2
7. INSERT WITH THREADED HOLE 4
8. 4X12 SCREW 20
9. M6X70 SCREW 4
10. M6X30 SCREW 4
11. SCREW KNOB 4
ITEM QUANTITY
3. Place the threaded insert into the hole on the stand leg. Rotate the threaded insert using a screw driver
to align the screw holes with the hole in the foot bottom.
4. Insert the M6X70 screws to the holes in the foot and align with the threaded holes of the insert in the side
board and fasten.
Tools required: phillips screwdriver
To Next Page
Need help?
General
