Windsor Saber Compact SC20 User Manual (English)

Questions and Answers:

H
Hailey RobinsonJul 29, 2025
Why is there poor or no water pick-up with my Windsor Scrubber?
- C
  chadjenkinsJul 29, 2025
  Several issues can cause poor water pick-up in your Windsor Scrubber. Check for debris caught on the squeegee and remove it. Inspect the squeegee blades for wear and replace them if necessary. Clear any clogs in the vacuum hose. Ensure the vacuum hose is properly connected to both the squeegee and the recovery tank. If the vacuum hose is damaged, replace it. Also, check if the vacuum motor inlet screen is dirty and clean it. Make sure the recovery tank is sealed correctly; check the vacuum motor position and replace any damaged seals. Finally, if foam is filling the recovery tank, empty the tank and try using less detergent, a different detergent, or a defoamer.
D
danielle22Aug 2, 2025
What to do if there is little or no solution flow to the floor with my Windsor Scrubber?
- J
  James HansonAug 2, 2025
  If your Windsor Scrubber has little to no solution flow, start by checking if the solution tank is empty and fill it if needed. Ensure the solution flow is turned on and set to an appropriate level. Inspect the solution strainer for any clogs and clean it. Check the solution hoses for obstructions and clear them. For traction models, examine the solution solenoid valve for obstructions or sticking; clean or replace it as necessary.
T
Timothy JimenezAug 6, 2025
What to do if the vacuum motor does not run or runs slowly on my Windsor Scrubber?
- E
  Ernest ThompsonAug 7, 2025
  If the vacuum motor on your Windsor Scrubber isn't running or is running slowly, first, drain the recovery tank if it's full. Then, reset the circuit breaker. Check the motor wires and connections for any looseness. If these steps don't solve the problem, the vacuum contactor might be faulty and need replacement, or the vacuum motor brushes may be worn and require replacement and commutator check.
M
Megan MaddenAug 10, 2025
How to improve poor scrubbing performance of my Windsor Scrubber?
- K
  Katherine MorganAug 11, 2025
  If your Windsor Scrubber's scrubbing performance is poor, start by removing any debris caught in the scrub brush. Replace the brush or pad if it's worn. For further assistance regarding detergent, brush, or pad usage, contact an equipment or application specialist. If you have a traction model, increase the brush pressure. Ensure the batteries are fully charged.
T
Travis MillerAug 14, 2025
What to do if my Windsor Scrubber has no power?
- T
  Thomas PearsonAug 14, 2025
  If your Windsor Scrubber has no power, check all battery cable connections. If you have a traction model, ensure the emergency shut-off is not activated and reset it if necessary. Clean any corrosion from the battery connections. If these steps don't restore power, the main contactor or the power switch might be faulty and need replacement.
M
Michael ZunigaAug 19, 2025
Why does the brush motor not run or runs slowly on my Windsor Scrubber?
- M
  Margaret PrattAug 19, 2025
  If the brush motor on your Windsor Scrubber is not running or running slowly, begin by resetting the circuit breaker. Check the motor wires and connections for any looseness. If the issue persists, the brush motor contactor might be faulty and require replacement, or the brush motor brushes may be worn and need replacement, along with a check of the commutator.