Windsor SENSOR S12 Maintenance Guidelines

5
Upright Vacuum
Call: 1-800-USA-CLEAN (800-872-2532) Click: www.usaclean.com Fax: 1-888-USA-CLEAN (888-872-2532)
Windsor Sensor
Removing a Clog
These are general maintenance guidelines.
Please consult your owner’s manual prior to performing any repairs or maintenance on this machine.
**Before you begin: Turn the machine off and unplug it.
1. Push the button
on the front of the
vacuum body to
release the body
from the base.
2. Pull the body up
to remove it from
the base.
3. Pull the neck
down parallel
with base and
using a wire coat
hanger or at tip
screwdriver, check
for a clog in the
neck.
4. Pull hose from
base. Check for a
clog using a wire
coat hanger or a
at tip screwdriver.
5. Flip the base
over and open the
inspection door to
check for a clog.
6. Reverse steps 1
and 2 to reattach
the body to the
base.
Tools Needed
A. Flat tip
screwdriver
B. Wire coat
hanger

Windsor SENSOR S12 Specifications

General

Brand	Windsor
Model	SENSOR S12
Category	Vacuum Cleaner
Language	English