wsm L503 User Manual

9-S12
L3130 · L3430 · L3830 · L4630 · L5030, WSM
ELECTRICAL SYSTEM
[2] ELECTRONIC INSTRUMENT PANEL (INTELLIPANEL)
(1) Testing, Setting and Adjusting by Electronic Instrument Panel (IntelliPanel)
The following settings, adjustments and testing can be done by using the IntelliPanel.
• Testing : Check a voltage of various sensor or rotation of engine.
• Setting or Adjusting : Input the various data to IntelliPanel or ECU.
• Error Information : Confirm or clear the error information.
CAUTION
• To perform the testing of the IntelliPanel the operator must be seated on the tractor.
■ Mode Selection
Select a corresponded mode by the following procedure, and do
the test, the adjustment, the setting, and the confirmation
respectively.
1. While holding down both the display mode switch (2) and the
travel speed switch (3) at once, turn the main switch to ON or
START position.
2. Mode selection display is indicated on the LCD.
3. Press the display mode switch (2) and the flashing part moves.
4. Hold down the display mode switch (2) for more than 2 seconds,
and the buzzer rings and flashing symbol is selected.
NOTE■
• To save entire and review the conditions, usually hold down
the Display Mode switch (2) until the buzzer rings.
• When a setting has been saved or an adjustment mode in
any mode, be sure to turn off the main switch to end the
procedure.
W1010725
W1083952
(1) Liquid Crystal Display (LCD)
(2) Display Mode Switch
(3) Travel Speed Switch
(A) Mode Selection Display for HST
and Manual Transmission Model
(B) Mode Selection Display for GST
Model
Symbol Mode Necessary Situation
A Test Mode • When the checking of sensor voltage or engine revolution is required.
B Traveling Speed Coefficient Input Mode
• When the IntelliPanel is replaced or changed.
• When the tire size is changed.
C PTO Coefficient Number Input Mode • When the IntelliPanel is replaced or changed.
D Error Information Reset Mode • When deleting the error information.
E GST Lever Sensor Fine-adjustment Mode
• When the GST lever sensor is replaced or changed.
• When the ECU is replaced or changed.
F GST Valve Fine-adjustment Mode
• When the GST valve is replaced or changed.
• When the ECU is replaced or changed.
G GST Shift Shock Fine-adjustment Mode • When the shifting shock is not comfortable.
H Error Information Display Mode • When checking the error history.
I Transmission Model Input Mode
• When the IntelliPanel is replaced or changed.
• When the HST range shift lever sensor is replaced or changed.
J Speed Unit Input Mode • When the IntelliPanel is replaced or changed.
KiSC issued 02, 2007 A

wsm L503 Specifications

General

Brand	wsm
Model	L503
Category	Tractor
Language	English