1. INSTALL
ZONE
****
12:00 am
ENTER PIN
12:00 am
Initializing Keyfob Remotes
Press and hold the ARM button on the Keyfob remote for 3-4 seconds
and then release it. This initializes the remote and picks a random
code that is used when it is registered with the Console.
Registering the Keyfob Remote with the Console
Press either of the Menu Start up/down buttons (under the Console’s lid to the
right of the display). The display then shows ENTER PIN (Personal Identifi cation
Number) in the top line.
The default PIN is 0000, so press 0000 on the keypad, or enter your PIN if you
changed it (see Security System Owner’s Manual). This clears the top line and shows
* for each number entered.
This takes you to the fi rst level of the menu at step 1. This is the INSTALLATION
level. When you see INSTALL on the display. Press OK and the display looks like
this:
Now simply press any button on the Keyfob remote. The Console acknowledges that
it has been registered by beeping and displaying RMOT 1 SET.
Repeat this for any other Keyfob Remotes you want to register. The display
increments to RMOT 2 SET, etc, as you install more remotes.
Press Clear to back out of the menus. You are asked to confi rm, 1. YES, 2 NO.
Press 1 to go back to the HOME CONTROL screen. Press 2 to stay in the INSTALL
menu.
Arming the system
Pressing ARM HOME on the Console arms all Door/Window Sensors instantly.
Motion Detectors will not trip the system when it is armed in the ARM HOME mode.
Pressing ARM AWAY arms with an exit delay and an entry delay, to give you time to
disarm the system after you enter your home. These delays will be what you specifi ed
for your ENTRY DELAY (30 second default) and EXIT DELAY (1 minute default).
See your security system owner’s manual for more information.
Pressing ARM on the Keyfob remote always arms in the AWAY mode. This arms
all Door/Window Sensors AND Motion Detectors, but arms them instantly.
Disarming the system
Pressing DISARM on the Keyfob remote disarms the system instantly.
To disarm from the Console: Enter your 4 digit PIN (Personal Identifi cation Number)
this will be 0000 unless you changed it.
Entering the PIN clears the top line and shows * for each number entered.
If the unit is armed it will disarm when the PIN is entered, and return to the time
display, with DISARMED in the top line.
DISARMED
****
12:00 am
ENTER PIN
12:00 am
Then after a short delay the display reverts to HOME CONTROL mode.
Panic Alarm: Pressing BOTH Panic buttons on the Keyfob remote at the same time
trips the alarm, even if the system was not armed.
To Next Page
Need help?
General
