Load trays with the correct weights
Check the Paper Tips Page
Calibrate colors
All trays in the printer require a paper setting. The default is laser paper, 60-90 g/m
2
(16-24 lb. bond). If you
load any other paper weight or type, you must set that new paper at the front panel. Printing with the wrong
setting can cause print-quality problems or damage the fuser.
60 g/m
2
– 220 g/m
2
16 – 28 lb. bond
50 – 80lb. cover
100 – 110 lb. index
60 g/m
2
– 169 g/m
2
16 – 40 lb. bond
50 – 60 lb. cover
65 – 90 lb. index
60 g/m
2
– 105 g/m
2
16 – 28 lb. bond
60 g/m
2
– 105 g/m
2
16 – 28 lb. bond
75 g/m
2
– 105 g/m
2
20 – 28 lb. bond
Use only Xerox
Phaser
®
7700
transparency film.
Do not use glossy
inkjet paper, or
non-laser glossy
paper. Fuser damage
may result.
MPT
Tray 1
Tray 2, 3, 4
Tray 2
Tray 3, 4
For detailed information on supported papers, weights,
and front panel settings print the built-in Paper Tips
Page
Color balance can be tuned at the printer's front panel by
following the procedure outlined on the Tutorial Page.
Highlight, mid-tone, and shadow adjustments can be
made.
Print the Menu Map
More help pages and diagnostic procedures are listed on
the printer's Menu Map under the Printable Pages
Menu.
2
1
3
4
PHASER 7700
READY TO PRINT
Xxxxxxx
Printable Pages
Xxxxx Xxxxxxxxx
Xxxxxxxxx
Printable Pages
Xxxxxxx Xxxxxxxx
Print Paper Tips Page
Xxxxxxxxx Xxxxxxx
Xxxxxxxx Xxxxxxxxxxx
Scroll to
"Printable Pages"
Press "OK"
Scroll to
"Print Paper Tips Page"
Press "OK"
2
1
3
4
Scroll to
"Printable Pages"
Press "OK"
Scroll to
"Print Menu Map"
Press "OK"
At the Front Panel:
PhaserSMART
TM
PhaserSMART is an automated printer diagnostic and
troubleshooting tool that uses your internet connection and a
web browser.
To access PhaserSMART via the web: go to www.phaserSMART.com, and
then enter your printer's IP address.
To launch PhaserSMART fromCentreWare IS: From a web browser, enter
your printer's IP address. Select Support. Select the Technical Support link
to access PhaserSMART.
To launch PhaserSMART from a Windows computer: From your Phaser
7700 printer driver Properties dialog box, select the Troubleshooting tab.
Select the Technical Support web link. www.PhaserSMART.xerox.com
To tune your printer for a particular brand or grade of
paper follow the steps on the Calibrate for Paper Pages.
This may also be necessary if the temperature or
humidity changes significantly.
Calibrate for paper
Front panel buttons
the Best
Getting
Print Quality
Cancel
Printing
Up Arrow
OK
Information
Down Arrow
Back
Need help?
General