Xerox WorkCentre 5330/5335 User Instructions
Make a Copy Using the Duplex Automatic Document Feeder (DADF)
NOTE: Use the DADF for multiple or single pages. Use the Document Glass for single
copies or paper that cannot be fed using the DADF.
1. Load the original document in the DADF.
2. On the Control Panel, press the [Clear All] button to clear previous copy settings.
3. Select the [Copy] button on the Touch Screen.
4. Using the numeric keypad on the Control Panel, enter the required number of
copies.
5. Select other copy settings for the job if required.
6. Press the [Start] button on the Control Panel to begin copying.
Make a Copy Using the Document Glass
NOTE: The Document Glass accepts paper sizes from 15 x 15 mm (0.59 x 0.59 in.) to
A3 (297 x 432 mm / 11.6 x 17 in.). The Document Glass automatically detects standard
paper sizes.
1. Load the original document face-down on the Document Glass.
2. On the Control Panel, press the [Clear All] button to remove any previous copy
settings.
3. Select the [Copy] button on the Touch Screen.
4. Using the numeric keypad on the Control Panel, enter the required number of
copies. The number of copies will be displayed in the upper, right corner of the
Touch Screen.
1. To change the number of copies, press the [C] button, and then re-enter
the required number.
2. To stop a copy job, press the [Stop] button. To continue the job, select the
[Resume] button.
3. To cancel the job, select the [Cancel] button.
5. Select any other required copy settings.
6. Press the [Start] button on the Control Panel to begin copying.
To Next Page
Need help?
General
