Xiaomi Redmi Earbuds S User Manual

PANTONE Cool Gray 11 C
80g金东太空梭
50mm
70mm
400mm
Redmi Earbuds S User Manual
Product Overview
Charging Case
1
Micro USB
Charging Port
Charging Indicator
Charging
Pins
Microphone
Indicator
Multi-function Buon
M
Charging Contact Points
L S
Earbuds
The earbuds come with the size M of ear tips
installed, you can switch to size S or L if the
installed size does not suit your ear.
2
Wearing
Gently insert the earbud into the ear canal, make
sure it is not easy to sway when shaking your head.
Please pay aention to adjust the earbud to
expose the microphone during calls.
3
Reset Earbuds
If the earbuds cannot connect properly, please
carry out the following steps to reset: Remove
the earbuds from the charging case, and make
sure they are turned off. Press and hold the
multi-function buon on both earbuds for about
15 seconds. Aer the indicator alternately blinks
red and white three times for twice, then release
the buon and place the earbuds back in the
charging case. Delete the earbuds from the list
of paired devices on your device, and then pair
them with your device again.
7
Switch between single and dual earbud:
When both earbuds are connected successfully,
they are in dual-earbud mode. Place one of the
earbuds back into the charging case and close
its lid, the other earbud will automatically enter
the single-earbud mode. Remove the earbud
from the charging case, the dual-earbud mode
will automatically be restored again.
6
Connection
Automatic Connection:
1. Remove both earbuds from the charging case
simultaneously, and wait 2–3 seconds for the
earbuds to automatically connect with each
other. Make sure the Bluetooth is enabled on
your device. When the indicator of the le or
right earbud slowly blinks white, search for
"Redmi Earbuds S" on your device.
2. Once your device and earbuds are successfully
connected, your earbuds will automatically
connect to the previously paired device (the
Bluetooth is enabled) when they are turned on.
Note: If you cannot pair the earbuds, place them
back in the case and repeat the previous steps.
5
Press and hold
for 1 second
Indicator turns
white
Press and hold
for 5 seconds
Indicator is red for
about 2 seconds
Turning On
Once you remove the earbud from the charging
case, it automatically turns on.
In case the earbuds are not in the charging case
and turned off, press and hold the multi-function
buon for 1 second till the indicator turns white.
Turning Off
Once you place the earbud into the charging
case, it automatically turns off.
When the earbud is turned on, press and hold
the multi-function buon for 5 seconds till the
indicator turns red.
Charging
Before using the device, please tear off the
protective film from the earbuds' contact points
to fully charge them and their charging case.
Connect the charging cable to the charging case
and keep the earbuds inside the case to charge
simultaneously.
The indicator is red while charging, and changes
to white once fully charged, then goes off aer
1 minute.
4
Protective Film
8
Function Overview
Answer/End calls
Gently press the multi-function buon to answer/
end calls.
Reject a call
Press and hold the buon for 1 second to reject
a call.
Press
Press and hold
for 1 second
The following functions can be used on
both earbuds:
Manufactured for: Xiaomi Communications Co., Ltd.
Manufactured by: Dongguan Yingsheng
Electronic Technology
Co., Ltd.
(a Mi Ecosystem company)
Address: Suite 1304, 13/F, Project Phrase 2 of
Gaosheng Tech Tower, Gaosheng Tech Park,
No.5 Longxi Road, Zhouxi Community, Nancheng
District, Dongguan City, Guangdong - 523000,
China.
Imported by: Xiaomi Technology India Pvt. Ltd.,
Orchid (Block E), Embassy Tech Village,
Devarabeesanahalli, Marathahalli-Sarjapur
Outer Ring Road, Bangalore – 560103, Karnataka
For Consumer Complaints Contact: Manager,
Customer Care, Xiaomi Technology India
Pvt. Ltd., Ground Floor, AKR Infinity, Sy. No.113,
Krishna Reddy Industrial Area, 7th Mile, Hosur
Road, Bangalore – 560 068, Karnataka,
Phone No.1800 1036286,
Email: service.in@xiaomi.com
For further information, please go to www.mi.com
Press the multi-function buon to play/pause
the music while using the earbuds.
Turn On Voice Assistant
Double press the multi-function buon to enable
the voice assistant while using the earbuds.
Note: The function of voice assistant and quick
wake-up must be supported and enabled on
your device.
Press
Play/Pause Music
Double press
Answer a Second Call/Switch between Calls
Press the multi-function buon to answer the
second incoming call during an ongoing call.
Double press the multi-function buon to switch
between the two calls.
Switch between Earbuds and Device
During a call, press and hold the multi-function
buon for 1 second to switch between the
earbuds and your phone.
Mute/Unmute
Double press the multi-function buon to mute/
unmute the earbuds during an ongoing call.
Enable/Disable Game Mode
When playing games with your phone and earbuds
being connected, press the multi-function buon
three times to enable or disable the game mode.
In the game mode, the audio delay and latency
can be effectively reduced.
Precautions
Warning
1. Do not disassemble, repair or modify the product
for any reason, as this may cause fire or even
completely destroy the product.
2. Do not expose the product to environments
where the temperature is too low or too high
(below 0°C or above 45°C).
3. Keep the indicators away from the eyes of
children and animals while using the earbuds.
4. Do not use this product during thunderstorms.
Thunderstorms may cause the product to
malfunction and increase the risk of electric
shocks.
5. Do not wipe and clean the earbuds or their
case with alcohol or other volatile liquids.
6. Avoid any contact with liquids.
7. Excessive sound pressure from the earbuds
can cause hearing loss.
Name: Bluetooth Earphones
Model: TWSEJ05LS
Frequency Band: 2402-2480 MHz (Bluetooth)
Max RF Output Power: < 20 mW
Earbuds
Dimensions: 2.67 cm × 1.64 cm × 2.16 cm
Net Weight: Approx. 4.1 g (per earbud)
Wireless Range:
10 m (in an obstacle-free environment)
Baery Capacity: 43 mAh (per earbud)
Charging Time: Approx. 1.5 h
Music Playback Time: Approx. 4 h (earbuds only);
approx. 12 h (charging case)
Standby Time: Approx. 150 h
Input: 5 V 100 mA
Baery Type: Lithium-ion Baery
Wireless Connectivity: Bluetooth 5.0
Bluetooth Profiles: HFP/A2DP/HSP/AVRCP
IP Rating: IPX4 (earbuds only)
Specifications
Charging Case
Dimensions: 6.2 cm × 4 cm × 2.72 cm
Input: 5 V 500 mA
Output: 5 V 150 mA
Charging Time: Approx. 2 h
Baery Capacity: 300 mAh
Baery Type: Lithium-ion Baery
Illustrations of product, accessories, and user
interface in the user manual are for reference
purposes only. The actual product and functions
may vary due to product enhancements.
9 10 11 13 1512 14
Note
1. If the product has not been used for more
than 2 weeks, it is recommended to charge
the product before use.
2. Only use certified chargers supplied by qualified
manufacturers.
3. Continuous use of the earbuds for a long time
is detrimental to one's hearing. Do not use
the earbuds at a high volume for any extended
period.
4. Using earbuds can reduce the perception of
external sounds. Do not use earbuds in
environments that may threaten safety. It is
recommended to only use a single earbud
when outdoors.
Due to the connection characteristics of the
Bluetooth signal, in dense environments with
2.4 GHz electromagnetic signal interferences,
there may be occasional disconnects or no
sound.
Danger of explosion if baery is incorrectly
replaced. The baery shall not be exposed to
excessive heat such as sunshine, fire or the like.
The Bluetooth® word mark and logos are
registered trademarks owned by Bluetooth SIG,
Inc. and any use of such marks by TWSEJ05LS
is under license. Other trademarks and trade
names are those of their respective owners.
Caution
Read this manual carefully before use, and
retain it for future reference.

Xiaomi Redmi Earbuds S Specifications

General

Brand	Xiaomi
Model	Redmi Earbuds S
Category	Headphone
Language	English