45
Use appropriate servo arm:
K - (23T)
H - (24T)
F - (25T)
901303
SB M3x3
902310
SH M3x10
902306
SH M3x6
Screw from servo
(NOT INCLUDED)
Insert rod through hole in brake
arm. Bend rod to proper shape.
Approx.15mm
Do not overtighten
screws; pivots must
rotate freely
Thread
6mm THREAD
8mm THREAD
9. CARB LINKAGE & BODYMOUNTS
HUDY ALU SERVO HORNS
#293494 23T KO Propo, Airtronics, JR, Sanwa
#293495 24T Hitec
#293496 25T Futaba
DETAIL
#332630 ADJ. TURNBUCKLE L/R 25 MM - HUDY SPRING STEEL™ (2)
#302663 COMPOSITE BALL JOINT 4.9MM - OPEN (8)
#362650 BALL END 4.9MM WITH THREAD 6MM (2)
#362651 BALL END 4.9MM WITH THREAD 8MM (2)
OPTIONAL REAR STIFFENER LINK
IMPORTANT
6.3mm
It is important to have the exact length of the linkage.
Too long or too short link will cause the chassis to
bend and unwanted tweak problems. To check that
the legth is correct, composite balls must move freely.
#334061-O
ALU BRAKE POST ARM - SWISS 7075 T6 - ORANGE
NOTE
ORIENTATION
IMPORTANT:
The composite holders and servo horn orientation
depend on the servo type and servo position which
can be mounted either from top of the radio plate
or from the bottom.
To Next Page
Loading...
Need help?
General
