Xray NT1 User Manual

48
AFTER THE SHOCK IS ASSEMBLED YOU HAVE TO SET THE SHOCK REBOUND.
➊ Release the shock cap by 2-3 turns.
➋ Push the shock shaft fully up. For the first time the extra oil will release through the hole in the alu cap-nut.
➌ Tighten the shock cup. When tightening the shock cap, extra oil will again release through the hole in the alu
cap - nut. When tightening, the shock shaft will push out from the shock body.
RELEASE
2-3 turns
TIGHTEN
FULLY
REBOUND CHECK
It is very important to push the shock shaft into the shock body slowly otherwise air can come into the shock
body which would create bubles.
100% rebound - repeat step 2 and 3 two - three times
75% rebound - repeat step 2 and 3 until the shock shaft will push out 75% of its length
50% rebound - repeat step 2 and 3 until the shock shaft will push out 50% of its length
25% rebound - repeat step 2 and 3 until the shock shaft will push out 25% of its length
0% rebound - repeat step 2 and 3 until the shock shaft will push out 0% of its length
If the shock shaft does not rebound enough, you will have to refill the shock with shock oil, and then repeat
the bleeding and rebound adjustment procedure.
REBOUND ADJUSTMENT
➊ ➋ ➌
SHOCK DAMPING
SPRING RATE SELECTION
4x
4x
LONGER SPRINGS
SHORTER SPRINGS
10. SHOCK ABSORBERS
0% 50%
75%
100%
25%
NOTE ORIENTATION
(SHINY FINISH SIDE)
NOTE ORIENTATION
(SHINY FINISH SIDE)
SHOCK LENGTH ADJUSTMENT:
It is VERY important that all shocks are equal length.
Fully extend the shock absorber and measure the end-to-end length; we recommend using
digital calipers to give an accurate measurement. If a shock absorber is shorter or longer than
others, adjust the shock length by tightening or loosening the ball joint on the shock rod.
#308031-O
ALU XRAY SHOCK SPRING RETAINING COLLAR - ORANGE (4)
FRONT SPRINGS
338182 PROGRESSIVE C=4.0-5.6 OPTION
338183 C=4.6 DARK-BLUE OPTION
338184 C=5.0 VIOLET OPTION
338185 C=5.4 LIGHT-PURPLE INCLUDED
338186 C=5.8 PURPLE OPTION
338187 C=6.3 LIGHT-RED OPTION
REAR SPRINGS
338281 PROGRESSIVE C=3.7-4.7 OPTION
338286 C=3.6 DARK-BLUE OPTION
338296 C=4.0 VIOLET INCLUDED
338287 C=4.5 LIGHT-PURPLE OPTION
338297 C=5.0 PURPLE OPTION
338288 C=5.6 LIGHT-RED OPTION
Install the pivot balls with Professional
Multi Tool (HUDY #183011)

Xray NT1 Specifications

General

Brand	Xray
Model	NT1
Category	Motorized Toy Car
Language	English