Xtool P2 Instructions

Model: MXP-K503-50W
100–120VAC, 60Hz, 350W
Storage Temperature: 5–30℃
FCC ID: 2AH9Q-MXPK503
This product complies with 21 CFR 1040.10 and 1040.11
except for deviations pursuant to Laser Notice No.50, dated
June 24, 2007.
Caution—Visible and invisible
laser radiation when open and
safety interlocks defeated.
Avoid exposure to beam.
xTool P2
Made in China
Makelock Co., Ltd.
D1.1.1_KL010210000
LASER
4
DANGER
AVOID EYE OR SKIN EXPOSURE TO
DIRECT OR SCATTERED RADIATION
Laser tube of the device has a silicone rubber casing, which can effectively shield
the internal power cord. If you find the cover is loose and the power cord is
exposed, stop operating and contact customer service personnel.
4. Electrical safety
■ Do not open any access panel on the device when the device is connected to
the power supply. Accidental contact with the power supply may cause injury.
■ Do not touch any electronic area with your hands or other tools when the
machine is connected to a power supply.
■ The power switch is on the back of the device. Press (-) to power it on and
pressing (o) to power it off.
Read the following warnings and suggestions carefully:
LASER
4
DANGER
AVOID EYE OR SKIN EXPOSURE TO
DIRECT OR SCATTERED RADIATION
On xTool P2, the warning and instruction signs are labelled where physical injuries
or damage to the machine may be caused before and/or during operation. If a sign
is damaged or lost, replace it immediately. You can use the following template to
print the sign you need.
5. Warnings and instruction signs
Read the following warnings and suggestions carefully:
3. Fire safety
A high-density laser beam is used by the device to irradiate the material to be cut or
engraved, so as to heat up the material surface and vaporize the material without
burning. But most materials are inherently flammable and may be ignited to form
an open flame that can burn down the device (even if it is made of flame-retardant
materials) and its surroundings. Experience shows that vector cutting with a laser is
most likely to produce an open flame. In particular, acrylic has proven to be
extremely flammable in vector cutting.
■ Do not stack materials (especially organic ones, such as paper) around the
machine. They may cause the spread of flames and increase the risk of material
ignition.
■ Do not leave the machine unattended when it is working. If the machine works
with setting errors and is left unattended for a long period of time, or if a
mechanical or electrical fault occurs, a fire may be caused.
■ Clean the device regularly. Excessive accumulation of residues and chippings
from cutting and engraving would increase the risk of fire. The tray needs be
removed and cleaned periodically to ensure that there is no residue or chipping in
the device.
■ Ensure that the area around the machine is clean without any cluttered
flammable materials, explosives, or volatile solvents, such as acetone, alcohol, or
gasoline.
■ Keep a fire extinguisher and perform regular maintenance and inspection of it.
Do not leave the
device unattended
when it is working.
Keep combustible
materials away
from the device.
4 5

Xtool P2 Specifications

General

Brand	Xtool
Model	P2
Category	Cutter
Language	English