Xtralis VESDA-E VEU-A00 User Manual

VESDA-EVEU-A00 Product Guide
www.xtralis.com 59
5.5 Configuration Options
The VESDA-E VEU-A00 detector can be configured using the Xtralis VSC software.
The following sections describe the configuration options available in Xtralis VSC.
5.5.1 General Options
The General options include some basic identification information for the detector.
Figure5-12: General Options
The General configuration options for the detector are as follows:
l Network Name: The name of the VESDAnet network. (The user can leave this blank if desired.).
l Location: A description of the physical location of the detector. This name will appear on Xtralis VSC
and on the LCD display of the A10 model detector.
l Serial Number: The serial number of the device. This is factory set and cannot be changed.
l VESDA Zone: The unique zone number used to link this detector and remote display/relay devices or
remote relay which output alarm and trouble status for this detector to the Fire Alarm Control Panel.
Authentication
l Change Password: The password used to authenticate Ethernet and WiFi access. Refer to Section
5.3.1 on page 54 for further information.
5.5.2 VESDAnet Options
The VESDAnet options provide the ability to control network data transmission behaviour for VESDAnet
connections.
Note: Refer to Section 5.6 for the default settings.

Xtralis VESDA-E VEU-A00 Specifications

General

Brand	Xtralis
Model	VESDA-E VEU-A00
Category	Smoke Alarm
Language	English