Yaesu FT DX 9000 CONTEST - MANUAL 2 User Manual

Name: Yaesu FT DX 9000 CONTEST - MANUAL 2
Brand: Yaesu
Rating: 5 (1 reviews)

168 pages

To Next Page

9000 Contest

Operation Manual

General Description3
- About this Manual3
- Conventions Used in this Manual3
- Table of Contents4
Before You Begin6
- Connecting AC Power6
- Configuring Your FT DX 9000 Using the Menu6
- Connecting and Selecting the Microphone7
- Extending the Front Feet7
- Adjusting the Main Dial Torque8
- Restarting Power after a Voltage Fluctuation8
- Resetting the Microprocessor9
Features10
Accessories12
Options13
Installation and Interconnections14
- Antenna Considerations14
- About Coaxial Cable14
- Grounding15
- Connection of Antenna and Power Cables16
- Connection of Microphone, Headphones and FH-2 Remote Control Keypad17
- Key, Keyer, and Computer-Driven Keying Interconnections18
- VL-1000 Linear Amplifier Interconnections19
- Interfacing to Other Linear Amplifiers20
Plug/Connector Pinout Diagrams21
Front Panel Controls22
Rear Panel36
Frequency Display38
- FH-2 Operation39
Operation40
- Receiving on Amateur Bands40
- Operation41
- Operation on 60-Meter (5 Mhz) Band (U.S. Version Only)43
Basic Operation44
- CLAR (Clarifier) Operation on Main (VFO-A)44
- Lock45
- DIM45
- B-Disp off45
Convenient Features46
- P.BACK (Audio Playback) from VFO-A Receiver46
- MY Bands" Operation47
- Band Stack Operation48
- Custom Switch)48
- Rotator Control Functions49
- More Frequency Navigation Techniques50
- Antenna Selection51
- Receiver Operation (Front End Block Diagram)52
- IPO (Intercept Point Optimization)53
- Att54
- RF Gain (SSB/CW/AM Modes)55
Advanced Interference56
- Suppression Features56
- Using the VRF (Variable RF Front-End Filter)56
Interference Rejection57
- ROOFING (Roofing Filters)57
- Contour Control Operation58
- IF SHIFT Operation (SSB/CW/RTTY/PKT Modes)59
  - (SSB/CW/RTTY/PKT Modes)60
  - Using if Shift and Width Together60
- IF Notch Filter Operation (SSB/CW/RTTY/PKT/AM Modes)61
- Digital Noise Reduction (DNR) Operation62
- NARROW (NAR) One-Touch if Filter Selection63
- Digital Notch Filter (D.NOTCH) Operation64
- IF Noise Blanker (NB) Operation64
Tools for Comfortable and Effective Reception65
- AGC (Automatic Gain Control)65
  - SLOPED AGC Operation66
- Audio Limiter (AFL) Feature67
SSB/AM Mode Transmission68
- Phantom Voltage for Condenser Microphones69
Using the Automatic Antenna Tuner70
- ATU Operation70
- About ATU Operation71
- Lithium Battery Replacement72
SSB/AM Mode Transmission74
- Using the Speech Processor - SSB, am Mode74
- Adjusting the SSB Transmitted Bandwidth75
  - Parametric Microphone Equalizer76
- Low- Distortion CLASS-A Operation78
- Voice Memory80
Convenient Transmitter Accessories82
- VOX: Automatic TX/RX Switching Using Voice Control82
  - SSB/AM/FM Modes82
- Using the MONITOR82
- Split Operation Using the TX Clarifier (VFO-A Operation)83
  - Clarifier Offset Bar Indicator83
- Split-Frequency Operation84
  - Quick Split Operation85
CW Mode Operation86
- Setup for Straight Key (and Straight Key Emulation) Operation86
- Using the Built-In Electronic Keyer87
- Full Break-In (QSK) Operation87
- Setting the Keyer Weight (Dot/Space:dash ) Ratio88
- Selecting the Keyer Operating Mode88
- CW Spotting (Zero-Beating)89
- Using CW Reverse90
- CW Delay Time Setting91
- CW Pitch Adjustment91
CW Convenience Features92
- Contest Memory Keyer92
  - Message Memory92
  - TEXT Memory94
FM Mode Operation96
- Operation96
- Repeater Operation97
Convenient Memory Functions98
QMB (Quick Memory Bank)99
- QMB Channel Storage99
- QMB Channel Recall99
Memory Groups100
- Memory Group Assignment100
- Choosing the Desired Memory Group100
Memory Operation101
- Memory Storage101
- Memory Channel Recall101
  - Checking a Memory Channel's Status102
- Erasing Memory Channel Data102
- Moving Memory Data to the Main (VFO-A) Band103
  - Memory Tune Operation103
- Operation on Alaska Emergency Frequency104
  - 5167.5 Khz (U.S. Version Only)104
- Operation on the 60-Meter Band (U.S. Version)105
VFO and Memory Scanning106
- VFO Scanning106
- Memory Scan106
Pms107
Packet Operation108
RTTY (Radio Teletype) Operation109
Miscellaneous AFSK-Based Data Modes110
About the Transverter Output Terminal111
Menu Mode112
- Using the Menu112
  - Menu Mode Reset112
- Menu Mode Setting Table113
- Menu Mode Setting117
- Dial Swap Configuration (AF/RF GAIN Controls)117
Customized Option135
- About Customized Option135
Dual Receive Unit (RXU-9000)136
- Front Panel Controls136
- Dual Receive138
- Changing the Speaker Output Configuration143
- Adjacent Channel Monitor (ACM) -- CW Mode Only144
- RF Gain -- SSB/CW/AM Modes145
- Using the VRF (Variable RF Front-End Filter)146
- ROOFING/R.FLT (Roofing Filters)147
- CONTOUR/CONT (Contour) Control Operation148
- IF SHIFT Operation -- SSB/CW/RTTY/PKT Modes149
- SSB/CW/RTTY/PKT Modes150
- IF Notch Filter Operation -- SSB/CW/RTTY/PKT/AM Modes151
- NR/DNR (Digital Noise Reduction) Operation152
- Digital Notch Filter (DNF) Operation153
- IF Noise Blanke (NB) Operation154
- AGC (Automatic Gain Control)155
- Mute Feature -- VFO-A155
- Audio Limiter (AFL) Feature156
- Att156
RF Μ-Tuning Units (MTU-160, MTU-80/40, MTU-30/20)158
Optional Data Management Unit (DMU-9000)/ TFT Display Unit (TFT-9000)160
- Front Panel Controls160
- TFT Feature / Control Details162
- Rear Panel Connections163
- Connecting a GPS Receiver163
Specifications164

Questions and Answers:

Need help?

Do you have a question about the Yaesu FT DX 9000 CONTEST - MANUAL 2 and is the answer not in the manual?

Yaesu FT DX 9000 CONTEST - MANUAL 2 Specifications

General

Brand	Yaesu
Model	FT DX 9000 CONTEST - MANUAL 2
Category	Transceiver
Language	English

Related product manuals

Yaesu FT DX 9000 CONTEST - MANUAL 2 User Manual

Table of Contents

Questions and Answers:

Yaesu FT DX 9000 CONTEST - MANUAL 2 Specifications

Related product manuals