5-14
FUEL MANAGEMENT GAUGE
FUEL SENSOR INSTALLATION
Follow the notifications below.
1. Locate the sensor in a well ventilated area in boat between the engine and a water separator.
2. Place the sensor with the “UP” mark facing upward.
3. Use a fuel joint that is fitted to the fuel hose of the outboard motor.
4. Secure all fuel hose ends with a hose clamp with good anti-corrosion performance.
* For twin engine application, refer to Wiring diagram in this chapter.
See the installation manual in the package for further information.
IN
UP
OUT
To extension wire lead
Water separator
(Market obtainable)
B (–)
Pu (S)
Or (+)
Fuel flow
sensor
Fuel valve
IN OUT
Primer
bulb
Clamp
Clamp
Fuel tank
Nipple1/4-18NPT
(Market obtainable)
Inboard area
To extension wire lead if water detection switch is incorporated.
To Next Page
Loading...
Need help?
General
