Yealink CP935W Manual

Yealink CP935W Phone DECT and WiFi Configuration
Objective
This article will show you how to configure your Yealink CP935W Wireless Conference Phone for operation as either a
DECT or WiFi device.
The following topics are covered:
• DECT Setup
• WiFi Setup
• Switching Modes
• Factory Reset
Applies To
• Yealink CP935W
• Yealink W70B Base Station
• DECT Configuration
• WiFi Configuration
Procedures
DECT Setup
To configure the phone for DECT operation and then pair it with an operational Yealink W70B Base Station:
1. Power up the CP935W unit.
2. At the Select mode screen, select Dect Mode and press OK. The device will reboot.
https://support.8x8.com/devices-accessories/phones/yealink/Yealink_CP935W_Phone_DECT_and_WiFi_Configuration
Updated: Fri, 09 Feb 2024 21:08:10 GMT
Powered by
1

Yealink CP935W Specifications

General

Control type	Touch
Product type	IP conference phone
Voice codecs	AMR, G.711a, G.722, G.722.1C, G.723, G.726, G.729, G.729A, OPUS, PCMA, iLBC
Product color	Black
Speaker power	5 W
Noise reduction	Yes
Speaker diameter	56 mm
Bluetooth version	4.2
Display resolution	480 x 800 pixels
Phonebook capacity	1000 entries
Top Wi-Fi standard	Wi-Fi 4 (802.11n)
Security algorithms	256-bit AES, HTTPS, MD5, SRTP, TLS, WPA2
Microphone pick-up range	6 m
Number of microphone arrays	6
Conference call ways quantity	5
USB version	2.0
USB connector type	USB Type-C
USB ports quantity	1
Operating temperature (T-T)	-10 - 40 °C
Operating relative humidity (H-H)	10 - 90 %
Power consumption (max)	6 W
Power consumption (typical)	2.2 W

Weight and Dimensions

Depth	285.2 mm
Width	288.6 mm
Height	63.9 mm