Yealink SIP-T23G Quick Installation Guide

www.yealink.com
Wall Mount Quick Installation Guide
for SIP-T21(P) E2/T23G IP Phones
(V1.0)
This quick installation guide provides step-by-step instructions for mounting your IP
phone to a wall.
This guide applies to the following phone’s wall mount installation:
SIP-T21(P) E2 IP Phone
SIP-T23G IP Phone
The stand is required for wall mount installation, which is included with your IP phone.
Screws, wall anchors and applicable tools are also required for wall mount installation.
These are not included with your IP phones. You need to purchase them separately.
Adjusting the Hookswitch Tab
The IP phone is packaged with the hookswitch tab in desk mount position. Before
mounting the IP phone to a wall, you must set the hookswitch tab to wall mount
position.
1. Pull the hookswitch tab in the handset cradle.
2. Rotate the hookswitch tab 180 degrees.
3. Reinsert the hookswitch tab.
To adjust the hookswitch tab:

Yealink SIP-T23G Specifications

General

Backlight	Yes
Voice codecs	G.711a, G.722.2, G.726, G.729ab, iLBC
Volume control	Digital
Handset type	Wired handset
Product type	IP Phone
Product color	Black, Silver
Display resolution	132 x 64 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	3
Networking standards	IEEE 802.1p, IEEE 802.1Q, IEEE 802.1x, IEEE 802.3af
Ethernet LAN (RJ-45) ports	2
AC adapter input voltage	100 - 240 V
AC adapter output current	0.6 A
AC adapter output voltage	5 V
Power consumption (typical)	1.56 W
Number of handles included	- pc(s)
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %

Weight and Dimensions

Depth	188 mm
Width	209 mm
Height	150 mm