Yealink T21PE2 User Manual

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
270
send key. It is only applicable to the off-hook dialing.
The off-hook dialing includes: pick up the handset, press the Speakerphone key or press the line key
when the phone is idle.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled). The value configured by the parameter “account.X.dialplan.digitmap.apply_to.press_send”
takes precedence over that configured by this parameter.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter dialplan.digitmap.apply_to.prefix_key <y0000000000xx>.cfg
Description
It enables or disables the phone to apply the predefined string of the digit map after pressing a Prefix key.
Note: It works only if “dialplan.digitmap.enable” or “account.X.dialplan.digitmap.enable” is set to 1
(Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default 1
Digit Map for a Specific Line Configuration
The following table lists the parameters you can use to configure digit map for a specific line.
Parameter
account.X.dialplan.digitmap.enable
[1]
<MAC>.cfg
Description
It enables or disables the digit map feature for the account X.
Note: The value configured by the parameter “account.X.dialplan.digitmap.enable” takes precedence
over that configured by the parameter “dialplan.digitmap.enable”.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Parameter
account.X.dialplan.digitmap.string
[1]
<MAC>.cfg
Description
It configures the digit map pattern used for the dial plan.
Example:
account.1.dialplan.digitmap.string = <[2-9]x:86>3.T|0x.!|1xxx
Note: The string must be compatible with the digit map feature of MGCP described in 2.1.5 of RFC 3435. It
works only if “account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the para-
meter “account.X.dialplan.digitmap.string” takes precedence over that configured by the parameter “dial-
plan.digitmap.string”.
Permitted
Values
String within 2048 characters
Default Blank
Parameter
account.X.dialplan.digitmap.interdigit_long_timer
[1]
<MAC>.cfg
Description
It configures the time (in seconds) to wait before dialing an entered number if it matches part of any
string of the digit map for the account X.

Yealink T21PE2 Specifications

General

Brand	Yealink
Model	T21PE2
Category	IP Phone
Language	English