1 Introduction
The Yellowtec PUC² is a professional-quality USB soundcard for use with MAC or
PC. It is compatible with MAC OS 9 or higher, Windows XP (with Service Pack 2)
and Windows Vista (32 bit version).
With its Plug’n’Play operation PUC² is ready to go without installation of any drivers.
PUC² is powered through the computer’s USB port.
Several versions of PUC² are available, offering different audio input and output
formats and connections. The AES-3 interface is common to all versions.
Yellowtec has a policy of continually improving and updating its products, and may
from time to time make firmware upgrades or dedicated software for PUC² available
on our website. Please visit Yellowtec’s website www.yellowtec.com
from time to
time to benefit from new features and performance enhancements. Firmware
upgrades will be free of charge.
PUC² is capable of recording high-resolution audio at up to 192 kHz sample rate and
24 bit word-lengths using its ASIO driver.
2 Ready, Set Up, Go
Your PUC² is designed so that you can start using it right away. If you have never
used a PUC before, read this guide for help getting started.
If you are an experienced user, you may already know enough to get started. Make
sure you make yourself familiar with Chapter 4 “Advanced Operation”.
What’s in the Box
Your PUC² comes with a USB Y-cord to interconnect with your MAC or PC.
Setting Up your PUC²
Step 1: Simply interconnect PUC² with your computer using the supplied USB Y-cord.
Make sure you plug in both USB A-plugs (yellow and black) into two unused ports.
The yellow connector carries no data but will be needed to secure sufficient power
supply.
To Next Page
Need help?
General
