User’s
Manual
1st Edition : May 2020 (YMI)
All Rights Reserved, Copyright © 2020 Yokogawa Test & Measurement Corporation
IM D027-01EN
1st Edition 1/3
MT300
Digital Manometer
Firmware Update Procedure
This document explains the firmware update procedure for the MT300 Digital Manometer (hereafter
referred to as the MT300).
When updating the firmware, be sure to follow this instruction manual.
Trademarks
• Microsoft, Windows 8.1, and Windows 10 are registered trademarks or trademarks of Microsoft
Corporation in the United States and/or other countries.
• In this manual, the TM and ® symbols do not accompany their respective registered trademark or
trademark names.
• Other company and product names are trademarks or registered trademarks of their respective
holders.
Disclaimers
By downloading and installing this software, the customer agrees to all of the following disclaimers.
• Yokogawa bears no liability for any problems occurring as a result of downloading or installing this
software.
• Yokogawa bears no responsibility for any damage caused directly or indirectly as a result of using
this software.
• This software is provided free of charge, however no unlimited warranty against software defects
exists, nor is any claim made that the product is free of all defects whatsoever. Also, Yokogawa
is not always able to repair defects (“bugs”) in, or respond to questions or inquiries about this
software.
• Yokogawa reserves all rights to this software, including but not limited to all property rights,
ownership rights, and intellectual property rights.
PC System Requirements
• Personal computer (PC)
A PC with a Core2 Duo 2 GHz or faster CPU and 1 GB or more of memory
• OS
Windows 8.1 or Windows 10
Notes before Updating
Setup Parameters
When you update the firmware, the MT300 setup parameters will be reset to their factory default
values. Save them if necessary.
Installing the USB Driver
You can update the firmware by connecting the MT300 to your PC with a USB cable and using the
firmware update tool.
To use the tool, YOKOGAWA’s USB driver (YTUSB) must be installed in your PC. If it is not installed,
download it from the YOKOGAWA webpage.
For the installation procedure, see the manual that is downloaded with the driver.
Webpage: https://tmi.yokogawa.com/library/
File to download: USB driver (YTUSB)
To Next Page
Need help?
General
