Yokomo YD-2 AC User Manual

First,insertfourAA/LR6batteriesintothetransmitter.Whenrunningthecar,besuretoturnonthepowerswitchofthe
transmitterfirstandthenturnonthepowerofthecar.Ifyoudontfollowthisprocedure,therearepossibilitythatcarwillrun
outofcontrolandisdangerous.
Check thesteeringand throttle neutrals before driving. Make sure thatsteering wheels areto run straight,and throttle
positionareinneutralthatmotordoesnotstartmovingwhennotoperating.
※Whenturningontheswitchonthecarside,keepthetiresawayfromtheroadsurface.Sinceitmightbecomeverydanger-
ousthatcarmightruninvoluntarilywhenaneutralshiftoccurs.
●Howtousetransmitter
●GyroSensors
Whenstartingandendingtherun,followsteps①to②below.
Startrunning/SwitchON Endrunning/SwitchOFF
① ②
ON ON
Slidingtoright
Slidingtoright
Slidingtoright
Switch
Switch
Switch Switch
Switch
Switch
②①
OFF
Slidingtoleft
Slidingtoleft
Slidingtoleft
OFF
YOKOMOLTD. 4385-2Yatabe,TsukubaCity,IbarakiPrefecture,305-0861.JAPAN
TEL+8129-896-3888 FAX+8129-896-3889 E-Mailsupport@teamyokomo.com
Wiringconnectiondiagramandset,diagramofadjustmentpart
Switch2:SettingForwardorReverse
Switch1:SettingDigitalorAnalog
Maximumrudderanglesettingbutton
LED
servo
receiver
Usetheplasticscrewdriverincludedinthesettoadjusttheswitch
andsensitivity.
Drivingprocedureandmaximumrudderanglesetting
①Placeabodylesscarwithagyroonaflattableorground.
②Ifturningonthepowerwithoutthebody,thegyroLEDwillbe
blinkingfast.Thisisasignthatdetectsgyroneutralandsteering
neutral.Donotmovethevehiclebodyorsteeringwheelduring
detection.
③IftheLEDstopsblinkingandstayson,itisasignthatthe
neutralsettingiscompleted.
④However,ifthefastblinkingoftheLEDdoesnotchangeto
lightingandthenchangestoslowblinking,itisasignthatthe
normalneutralsettinghasfailedtocomplete,sostartoveragain
from①.
⑤Turnthesteeringwheeltotherightonthetransmitterside,
presstheswitchbrieflyatthepointwhereithitsthesteering
stopper,thered-bluelightblinkstwiceathighspeed,thenblue
lightsup,andredlightsupslowlyindicatesthatthesettinghas
beensaved.
⑥Next,assamewiththerightside,presstheswitchbrieflyatthe
pointwhereithitsthestopper.Thered-bluelightblinkstwiceat
highspeed,andthenthered-bluelightsturnonatthesametime,
itindicatesthatthesecondsettinghasalsobeensaved.
⑦Thesteeringissettoneutralandthegyroendpointsettingis
completed.
＊Thisproductcannotbeusedifthe3rdchannelofthetransmitter
ispushbuttontype.
＊Whenadjustingtheendpoint,adjustitwithintherangewherethe
loadisnotappliedtotheservo.Pleasenotethatwhenaloadis
appliedtotheservo,aloadsoundwillbegeneratedfromtheservo.
●Gyroneedtobefixedwithdoublesidedtapeinflatareaofupperdeckormain
chassis.
●Switch1(Rightside):Therearetwotypesofsignalsthattheservomoves:
analoganddigital.Thesetatthetimeofpurchaseisinthedigitalmodeused
bymanypeople.Iftheservodoesnotrespond,settheswitchuptomakeit
analog.
●Switch2(LeftSide):Settingtheoperatingdirectionoftheservowiththe
gyro.Thesetatthetimeofpurchaseisreversedandissetontheswitch.Iftry
turningthesteeringwheelbeforedrivingandtheservodoesnotmoveinthe
counterdirection,settheswitch2tothelower/forwardrotationagain.
Initial Setting on switches Switch 1 : Analog Switch 2 : Reverse Volume Rate : 50%

Yokomo YD-2 AC Specifications

General

Brand	Yokomo
Model	YD-2 AC
Category	Motorized Toy Car
Language	English