INSTALLATION & OWNER'S MANUAL
HIGH STATIC DUCTED
ELECTRIC HEATER WITH PLENUM
Models
MBC-MBH 25-65E
ELECTRICAL CONNECTIONS
All electrical wiring and connections must comply with
local standards.
Disconnecting device must have a contact separation of
at least 3 mm with all pole disconnected.
GENERAL PRECAUTIONS
Check that the power supply available agrees with
nameplate voltage.
Use adequate line protection.
The unit must be grounded.
Installation and maintenance of this air conditioning system should only be carried out by trained and qualified
personnel.
Regular maintenance operations such as cleaning the coils and air filters must be performed to keep the
units in proper operating condition.
SAFETY
T
EC
H
N
I
CA
L
G
U
I
D
E
CAUTION
Before undertaking any work on the unit, make sure that the power supply has been disconnected.
INDOOR UNITS
Each unit is shipped with the following items:
– an indoor unit ready for connection to the
condensing unit.
–a mounting bracket set.
–a technical guide.
–a control user guide.
INDOOR & OUTDOOR UNITS
OUTDOOR UNITS
The units are shipped complete with a charge of R22/
R407C refrigerant sufficient for a piping length of 5
meters.
To Next Page
Need help?
General
