YORK INTERNATIONAL
2
FORM 102.20-FA1 (1104)
This equipment is a relatively complicated appara-
tus. During installation, operation, maintenance or
service, individuals may be exposed to certain com-
ponents or conditions including, but not limited to:
refrigerants, oils, materials under pressure, rotating
components, and both high and low voltage. Each of
these items has the potential, if misused or handled
improperly, to cause bodily injury or death. It is the
obligation and responsibility of operating/service
personnel to identify and recognize these inherent
hazards, protect themselves, and proceed safely in
completing their tasks. Failure to comply with any
of these requirements could result in serious dam-
age to the equipment and the property in which it is
situated, as well as severe personal injury or death
to themselves and people at the site.
IMPORTANT!
READ BEFORE PROCEEDING!
GENERAL SAFETY GUIDELINES
This document is intended for use by owner-autho-
rized operating/service personnel. It is expected that
this individual possesses independent training that
will enable them to perform their assigned tasks
properly and safely. It is essential that, prior to per-
forming any task on this equipment, this individual
shall have read and understood this document and
any referenced materials. This individual shall also
be familiar with and comply with all applicable gov-
ernmental standards and regulations pertaining to
the task in question.
SAFETY SYMBOLS
The following symbols are used in this document to alert the reader to areas of potential hazard:
CAUTION identifi es a hazard which
could lead to damage to the ma chine,
damage to other equip ment and/or
en vi ron men tal pollution. Usually an
in struc tion will be given, together with
a brief ex pla na tion.
NOTE is used to highlight additional
information, which may be helpful to
you.
DANGER indicates an imminently haz-
ardous situation, which, if not avoided,
will result in death or serious injury.
WARNING indicates a potentially haz-
ardous situation, which, if not avoided,
could result in death or serious injury.
External wiring, unless specifi ed as an optional connection in the man u fac tur er’s prod uct
line, is not to be connected inside the control pan el cab i net. De vic es such as re lays, switch es,
transducers and controls may not be installed inside the control pan el. No external wir-
ing is al lowed to be run through the control panel. All wir ing must be in ac cor dance with
YORK’s pub lished spec i fi ca tions and must be per formed only by qual i fi ed YORK personnel.
YORK will not be re spon si ble for dam ag es/problems re sult ing from im prop er con nec tions
to the con trols or ap pli ca tion of im prop er con trol sig nals. Failure to fol low this will void the
man u fac tur er’s warranty and cause serious dam age to property or injury to per sons.
IAQ
Consider for IAQ compliance per
ASHRAE STANDARD 62-2001
To Next Page
Loading...
Need help?
General
