290699-YIM-B-0607
6 Unitary Products Group
REFERENCE
Additional information is available in the following refer-
ence forms:
• Technical Guide - D(CE, CG) 036-072, 292458
• Technical Guide - D(HE, HG) 036-060, 255038
• General Installation - D(CE, CG) 036-072 and
D(HE, HG) 036-060, 290699
RENEWAL PARTS
Contact your local York
®
parts distribution center for
authorized replacement parts.
APPROVALS
Design listed by CSA as follows:
• For use as a cooling unit only with or without
optional electric heat.
• For use as a forced air furnace with cooling
unit
• For outdoor installation only.
• For installation on combustible material.
• For use with natural gas or propane gas.
The installer should pay particular attention to the
words: NOTE, CAUTION and WARNING. Notes are
intended to clarify or make the installation easier. Cau-
tions are given to prevent equipment damage. Warn-
ings are given to alert installer that personal injury and/
or equipment damage may result if installation proce-
dure is not handled properly.
PRODUCT NOMENCLATURE
This product must be installed in strict compli-
ance with the enclosed installation instructions
and any applicable local, state, and national
codes including, but not limited to, building,
electrical, and mechanical codes.
Improper installation may create a condition
where the operation of the product could cause
personal injury or property damage.
D 5 C E A
PRODUCT GENERATION
3 = 3rd Generation
5 = 5th Generation
6 = 6th Generation
PRODUCT CATEGORY
D = Single Package Air Conditioner
(Air Cooled)
PRODUCT IDENTIFIER
CE = Cooling
VOLTAGE CODE
25 = 208/230-3-60
46 = 460-3-60
58 = 575-3-60
036 = 3 Ton
048 = 4 Ton
060 = 5 Ton
072 = 6 Ton
30 6 2 5
NOMINAL COOLING
CAPACITY
FACTORY INSTALLED
HEAT
A = Cooling Only
To Next Page
Loading...
Need help?
General
