Zebra GX420t User Manual

iii
12/14/07 GX420t / GX430t User Guide 980612-001 Rev. A
FCC Compliance Statement
This device complies with Part 15 rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital
Devices, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a residential
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the product manuals, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, the user is encouraged to do one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced RF service technician for help.
The user is cautioned that any changes or modifications not expressly approved by Zebra
Technologies could void the user’s authority to operate the equipment. To ensure compliance,
this printer must be used with fully shielded communication cables.
G Series Printers
• Vi ewi ng the laser output wi th certain optical i nstruments (f or exampl e, eye loops, magnifiers and mi croscopes) within
a distance of 100mm m ay pose an eye hazard.
• Use of control s or adjustments or perf ormance of procedures other than those specif ied herei n may resul t i n hazardous
radi ati on exposure.
• Do not tam per or attempt to repai r any sensor i nside this product. No servi ceabl e sensors insi de.
• Do not stare into Gap (Web) or Dispenser (Peel) sensors. Avoid possibl e exposure to hazardous laser radi ati ons.
Caution • CLA SS 1M LASER PRODUCT

Zebra GX420t Specifications

General

Print technology	Thermal transfer
Maximum resolution	203 x 203 DPI
Ribbon length	74 m
Media thickness	0.08 - 0.2 mm
Maximum media length	991 mm
Maximum roll diameter	127 mm
Supported paper width	104 mm
Media thickness (imperial)	0.003 - 0.0075 \
Maximum media length (imperial)	39 \
Supported paper width (imperial)	4.09 \
Connectivity technology	Wired & Wireless
Dimensions (WxDxH)	194 x 254 x 191 mm
Flash memory	4 MB
Certification	-FCC Part 15, -Subpart 15, - VCCI, -C-Tick, -EN55022 Class-B, -EN6100-3-2, -EN6100-3-3, -EN55024, -CCC, -CB Scheme IEC 60950: 1991 +A1 +A2 + A3 +A4, -TUV NRTL, -IRAM, -NOM, -AAMI.
Internal memory	8 MB
Built-in barcodes	Code 39, Code 49, Code 93, MaxiCode, PDF417, Postnet, QR Code, UPC-A, UPC-E
Page description languages	EPL2
Storage temperature (T-T)	-40 - 140 °F
Operating temperature (T-T)	5 - 41 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Power requirements	100 - 240 VAC, 50 - 60 Hz
Package weight	4100 g

Weight and Dimensions

Weight	2100 g