Zebra LS1203 User Manual

LS1203
http://www.zebra.com/ls1203
STEP 2 -CONNECT CABLE TO A HOST
STEP 1 - ATTACH CABLE TO SCANNER
Quick Start Guide
See Product Reference Guide for detailed information
RS-232
USB Keyboard Wedge
Attach Cable
Remove Cable (to change interface)
STEP 3 - SET UP INTERFACE (Scan Host Bar Codes)
STANDARD RS-232
OPOS/JPOS
IBM AT Notebook
IBM PC/AT and IBM PC COMPATIBLE
HID KEYBOARD EMULATION
IBM HAND-HELD USB
Important: Out of box, Keyboard Wedge and USB interfaces require no bar code scan setup. Bar codes are provided for complex programming or interface changes.
ADD AN ENTER KEY (CARRIAGE RETURN/LINE FEED)
Adding an Enter Key after scanned data; Scan all THREE bar codes in numerical order.
SCAN OPTIONS <DATA><SUFFIX> ENTER
RS-232
Keyboard Wedge
USB
Note: Power Supply Optional
NOTE: Cables may vary depending on configuration.
Or
ADD A TAB KEY
To add a Tab key after scanned data, scan all THREE Enter key bar codes above in numerical order then scan all FIVE bar codes below in numerical order.
SCAN SUFFIX
7
0
0
9
1 2
3 4
5
1 2 3
Scan ONE of the bar codes below Scan ONE of the bar codes below Scan ONE of the bar codes below

Zebra LS1203 Specifications

General

Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	Laser
Read rate (max)	100 reads/s
Tilt reading angle	-30 - 30 °
Linear (1D) barcodes supported	Codabar, Code 11, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128)
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Input voltage	5 V
Power consumption	100 mA
Power source type	DC
Product color	Black
Housing material	-
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	180.3 mm
Width	60.9 mm
Weight	122 g