EasyManuals Logo
Home>Zebra>Barcode Reader>RS5100

Zebra RS5100 Installation Guide

Zebra RS5100
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
RS5100 Back of Hand Mount
Installation Guide
Back of Hand Mount
The Back of Hand Mount (which includes a hand strap), allows the
RS5100 to be worn on the back of your hand and provides a remote finger
trigger. It is one size to fit all and is ambidextrous.
To attach the back of hand mount, perform the following three steps:
1. Install the strap to the back of hand assembly (there is a difference for
a right hand user and a left hand user)
2. Position the back of hand mount on the hand
3. Install the RS5100 onto the back of hand mount.
Install Strap: Right Hand User
To install the strap to the back of hand assembly for a right hand user:
1.
Hold the Y shape strap in one hand and the back of hand assembly in
the other hand.
2. Slide one end of the strap with the snap through the top left slot on the
back of hand assembly and snap into place.
3. Slide the other end of the strap with the snap through the bottom left
slot on the back of hand assembly and snap into place.
4. Slide the remaining long end of the strap with the velcro through the
right center slot of the back of hand assembly and velcro in place.
Install Strap: Left Hand User
To install the strap to the back of hand assembly for a left hand user:
1. Hold the Y shape strap in one hand and the back of hand assembly in
the other hand.
2. Slide one end of the strap with the snap through the top right slot on
the back of hand assembly and snap into place.
3. Slide the other end of the strap with the snap through the bottom right
slot on the back of hand assembly and snap into place.
4. Slide the remaining long end of the strap with the velcro through the
left center slot of the back of hand assembly and velcro in place.
Position Strap on Hand
To position the back of hand mount on the hand:
1. Slide your hand through the strap, with your thumb through the
smaller opening between the two snaps and your remaining four
fingers through the larger opening.
2. Adjust the velcro to a comfortable position.
3. Pull the finger trigger to place it over your index finger and slide the
finger trigger down the index finger.
4. Rotate the finger trigger so that the trigger button is easy access to
your thumb.
MN-003973-01EN-rs5100-back-of-hand-ig-en.fm Page 1 Thursday, May 21, 2020 2:42 PM

Other manuals for Zebra RS5100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zebra RS5100 and is the answer not in the manual?

Zebra RS5100 Specifications

General IconGeneral
Suitable forBarcode reader battery
Power source typeDC
Brand compatibilityZebra
Number of batteries supported4
Compatible battery technologies-
Product colorBlack, Yellow
LED indicatorsYes
Housing materialPlastic
Quantity per pack1 pc(s)
Harmonized System (HS) code85044055

Related product manuals