EasyManuals Logo
Home>Zephyr>Kitchen Appliances>AK9440BS

Zephyr AK9440BS User Manual

Zephyr AK9440BS
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
Monsoon Connect Use, Care, and Installation Guide
MONSOON
CONNECT
INSERT
CORE
Installation Instructions
Mounting Height, Clearance, & Ducting
A minimum of 8” round or 10” round duct for vertical ducting must be used to maintain maximum air
flow eciency. A 8” round duct may be used for horizontal ducting.
Always use rigid type metal ducts only. Flexible ducts could restrict air flow by up to 50%.
Also use calculation (on page 11) to compute total available duct run when using elbows, transitions
and caps.
ALWAYS, when possible, reduce the number or transitions and turns. If long duct run is required,
increase duct size.
If turns or transitions are required; install as far away from hood duct output and as far apart,
between the two as possible.
Minimum mount height between range top to hood bottom should be no less than 24”.
Maximum mount height should be no higher than 34”.
It is important to install the hood at the proper mounting height. Hoods mounted too low could result
in heat damage and fire hazard; while hoods mounted too high will be hard to reach and will lose its
performance and eciency.
If available, also refer range manufacturer’s height clearance requirements and recommended hood
mounting height above range.
For shipment and installation damages:
Ź Please fully inspect unit for damage before installation.
Ź If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or
replacement.
Ź If the unit is damaged by the customer, repair or replacement is the responsibility of the customer.
Ź If the unit is damaged by the installer (if other than the customer), repair of replacement must be
made by arrangement between customer and installer.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Zephyr AK9440BS and is the answer not in the manual?

Zephyr AK9440BS Specifications

General IconGeneral
Colorstainless steel
Hood Typeinsert
Venting Typeducted, external
Temperature Sensorno
Number of Fan Speeds6
CFM5 cubic feet per minute
Control Typebutton
Delay Startyes
Interior Lightyes
Remote Controlno
Voltage120 volts
Weight and Dimensions IconWeight and Dimensions
Depth19 1/4 inches
Height12 inches
Width40 3/8 inches
Net Weight55 pounds

Related product manuals