Zephyr LAYERS WALL DLA-E42ASSX User Manual

7. Install blower and blower plate into blower housing
by following the reverse instructions from step 2
then use the screws provided to complete installa-
tion. (Tot. 14). See Fig.7
8. Connect 9 pin male molex connector from blower
wire to 9 pin female molex connector on the capa-
citor wire. See Fig.8
WARNING! Place electrical wiring inside the motor housing.
The hood is now ready to be installed on the wall.
- 14 -

Zephyr LAYERS WALL DLA-E42ASSX Specifications

General

Brand	Zephyr
Model	LAYERS WALL DLA-E42ASSX
Category	Ventilation Hood
Language	English