NEED HELP? GIVE US A CALL 855.424.9892
16
INSTALLATION
WI-FI SETTINGS
Privacy Policy Consent - User must say Yes to access the following screens.
Status - Connected or Not Connected.
Network - Select the network name from a list or manually select the Network SSID.
Password - Enter the password.
IP Address - Enter an IP address.
Low Salt - When the controller determines salt level is low, an alert screen will appear
and the controller will beep. User will press the “OK” button to silence the beeping.
Additionally, if using Wi-Fi controllers, an email will be sent. The Salt Level icon on the
Main Menuhome screen will ash “ADD”. When user presses the Salt Level icon, the
Salt Level screen will appear. When salt is added, user will input how much salt is in the
cabinet and press “ACCEPT” button. Controller will then reset to show Salt Level = OK.
Low Temperature - When the controller detects temperatures close to freezing (below
40° F/4° C), an alert screen will appear and the controller will beep. The user will hit the
“OK” button to silence the beeping. Additionally, if using Wi-Fi controllers an email
will be sent. When the temperature rises above the low temperature threshold, the
controller will automatically reset alarm and stop beeping.
Water Usage - If controller detects water owing for 60 minutes without stopping,
an alert screen will be shown and controller will beep.
MANUAL REGENERATION
User can press “REGEN” button to force an immediate regeneration. The “NEXT”
button that appears on the screen allows the user to advance the cycle to the next
position.
FACTORY RESET
On Main Menu screen there is a button labeled “RESET”. Pressing this button
brings up Restore Defaults screen. Pressing “Yes” will return controller to
factory default settings.
OVERRIDE
Press [<] to turn on. If “96 Hour” is selected, unit will work no more than 4 days
without a regeneration. Default is “96 Hour” to be off. Leave this on if you have
Iron in your water.
Main Menu (Cont.)
To Next Page
Loading...
Need help?
General
