6
1MRS755312
Connectivity Packages
User’s Guide
REF 541/543/545
REM 543/545
RET 541/543/545
Supported IEDs:
• REF 541, REF 543, REF 545: Release 3.0
• REM 543, REM 545: Release 2.5
• RET 541, RET 543, RET 545: Release 3.0
Connectivity packages support IEC 61850, LON and SPA communication protocols
for the IEDs mentioned above.
Supported system products and tools:
• Communication Engineering Tool for COM 610
• Communication Engineering Tool for SPA-ZC 40x
• Communication Engineering Tool for MicroSCADA Pro SYS 600 *9.0 or later
and COM 500 *4.1 or later
• SCL Importer in MicroSCADA Pro SYS 600 *9.1 or later and COM 500 *4.2 or
later
For more information about the supported tools, refer to Chapter 4. Content and
usage of connectivity packages.
This user’s guide is divided into following sections:
Installation and uninstallation
This chapter describes the installation and the uninstallation of the connectivity
packages.
Connectivity Package Manager
This chapter introduces the funtionality of the Connectivity Package Manager and
the handling of the connectivity packages.
Content and usage of connectivity packages
This chapter describes the content and usage of connectivity packages in different
products.
Logical node naming
In this chapter you find the naming of logical nodes and the LN prefixes for RED500
IEDs.
1.4. Use of symbols
The information symbol points out safety related or other important information. It
also point out useful hints to the reader. The corresponding symbol should be
interpreted as follows:
Information icon alerts the reader to pertinent facts and conditions.
To Next Page
Loading...
Need help?
General
