TV settings
Open the TV menu as described in the OSD navigation section. This menu provides the
following settings:
Tuner mode
Adjust the signal settings to receive Antenna or Cable signals.
Country
Select the country you live in to scan for the correct signals.
Channels
Channel scan
Channel scan allows you to scan for channels. If you completed the setup wizard the first
time you turned on your TV, all available channels are listed.
Wait until the scan has finished; this will take several minutes.
Update scan
Update scan allows you to scan for new or deleted channels.
Wait until the scan has finished; this will take several minutes.
Single RF scan
You can manually add a digital channel by searching in specific UHF channels.
Analogue manual scan
You can manually add an analog channel by adjusting the settings here.
Channel edit
You can edit the detected channels, to change how they are displayed in the channel list.
Use the up or down directional keys to select a channel, direction, OK and number keys
to change the channel number or name.
Intelligent zapping
If Intelligent Zapping is on, then channels viewed for less than the period defined here
will not be added to the zapping memory.
To Next Page
Loading...
Need help?
General
