Acer H233H User Manual

7
English
Installation
To install the monitor on your host system, please follow the steps below:
Steps
1 Connect the video cable
a Make sure both the monitor and computer are switched off.
b Connect the VGA video cable to the computer.
c Connect the digital cable (only for dual-input models).
(1) Make sure both the monitor and computer are switched off.
(2) Connect one end of the 24-pin DVI* cable to the back of the
monitor and the other end to the computer's port.
(3) Connect one end of the 19-pin HDMI* cable to the back of the
monitor and the other end to the computer's port.
2 Connect the power cord
Connect the power cord to the monitor, then to a properly grounded AC
outlet.
3 Turn on the monitor and computer
Turn on the monitor first, then the computer. This sequence is very
important.
4 If the monitor does not function properly, please refer to the
troubleshooting section to diagnose the problem
* for selected models

Acer H233H Specifications

General

Pixel pitch	0.248 x 0.248 mm
Aspect ratio	16:9
Response time	2 ms
Display diagonal	23 \
Viewing angle, vertical	160 °
Contrast ratio (dynamic)	40000:1
Contrast ratio (typical)	250:1
Viewing angle, horizontal	170 °
Display brightness (typical)	300 cd/m²
HDCP	Yes
RMS rated power	3 W
Certification	CE, TÜV GS, ISO 13406-2
Product color	Black
Market positioning	-
Power management	ENERGY STAR
Mean time between failures (MTBF)	50000 h
LED indicators	Stand-by
Tilt angle range	-5 - 15 °
Panel mounting interface	100 x 100 mm
Power consumption (off)	0.72 W
Power consumption (standby)	0.76 W
Power consumption (typical)	31.7 W

Weight and Dimensions

Depth (without stand)	177.5 mm
Width (without stand)	561.6 mm
Height (without stand)	393.9 mm
Weight (without stand)	4770 g