20 - BIOS utility
BIOS UTILITY
The BIOS utility is a hardware configuration program built into
your computer's BIOS.
Your computer is already properly configured and optimized, and
you do not normally need to run this utility. However, if you
encounter configuration problems, you may need to run it.
To activate the BIOS utility, press F2 while the computer logo is
being displayed.
Boot sequence
To set the boot sequence in the BIOS utility, activate the BIOS
utility, then select Boot from the categories listed on the top of
the screen.
Setting passwords
To set a password on boot, activate the BIOS utility, then select
Security from the categories listed on the top of the screen.
Find Set Supervisor Password and enter a password to enable
this feature. Once you have entered a password for this feature,
you may then enable/disable Password on Boot.
Remember to select F10 to properly save and exit the BIOS utility
when you are done making changes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
