X163W
EN-9
POWER SAVING
The monitor will be driven into Power Saving” mode by the control signal from the display controller, as
indicated by the amber-color power LED.
State LED Light
ON Blue
Power Saving Mode Amber
The power saving states will be kept until a control signal has been detected or the keyboard or mouse is
activated. The recovery time from Active OFF state back to ON state is around 5 seconds.
DDC
To make your installation easier, the monitor is able to Plug and Play with your system if your system also
supports DDC protocol. The DDC (Display Data Channel) is a communication protocol through which the
monitor automatically informs the host system about its capabilities, for example, supported resolutions and
corresponding timing. The monitor supports DDC2B standard.
To Next Page
Loading...
Need help?
General
