27
OSD Message
a. Outline
b. The Description For OSD Message
Item Description
Auto Config
Please Wait
When Analog signal input, if User Press Hot-Key “Auto”, will show this message, and the
monitor do the auto config function.
Input Not
Supported
When the Hsync Frequency, Vsync Frequency or Resolution is out of the monitor
support range, will show this message. This message will be flying.
Cable Not
Connected
Analog-Only Model: When the video cable is not connected, will show this message.
This message will be flying.
No Signal
Analog-Only Model: When the video cable is connected, but there is no active signal
input, will show this message, then enter power saving.
To Next Page
Loading...
Need help?
General
